Automotive News

Car stereo is an integrated part of a car. Factories stereo have electrical wiring connectors that has all the wires housed in it.this set of wires include ground wire, wire for the speakers, memory and main power switch. An adaptive harness is to be purchased along with a after market radio. This will be far time consuming and also more power. This is a much simpler one compared to others. They are less expensive and they also have single switch system which is more advantageous than others. Its a simple plug in and playing type of stereo system.but how to remove a factory car stereo.

This discussion will be helpful for those aspiring to remove the factory car stereo easily without spending too much money and time. For this purpose some tools like screwdriver, quarter inch sockets, and quarter inch socket driver are required. Some steps to remove the factory car stereo are discussed below. They are a set of generalised directions which may be applicable to the car in picture since all cars are different but this definitely gives the reader an idea of how to get the car stereo removed.

In the first step the reveal-molding in the front of the dash is removed.

After the molding is removed, the next step is to remove the panel to reveal under the panel. To do this, the screws around the speedometer are removed. This goes along the bottom of upper part of dash cover. The panel on the side of the driver is removed.

In the next step the panel below the steering wheel is removed. This reveals screws that hold dash cover. There are snaps that help the dash keep it in place. These have to snapped and removed.

Now, the screws surrounding the faceplate that holds the radio are removed. Then the radio is free to pull and this is done in such a way that the antennae and connector are disconnected. When it is disconnected from the connections, the radio can be safely pulled out. A new faceplate that is of the right size for the specific vehicle is used. It must be made sure by the user that the fitting of the faceplate in reveal molding is proper.

In order to disconnect the power, the power plug to the stereo has to be located. The plug will generally have two colored wires namely red and yellow wire running to it. Using one hand, grasp one side of the plug while grasping the other side of the plug with your other hand. Once grasping the plug, squeeze them and pull them at the same time.

Hence by following the above directions, removing a factory car stereo becomes easy and can be done by any person with enough knowledge of dash covers and connections of stereos.

Looking to find the best deal on Auto Hifi, then visit www.powernetshop.at to find the best advice on Car audio for you.