Automotive News

There are few tools required for accomplishment of a car stereo handling task. The usage of such tools will reduce the man power required and makes it easy. One such tool is the crimping tool. Tools have always been one of the major contribution to new kind of car stereo handling process. This will definitely help in the easy handling and usage of wires. The traditional crimping tool is the mechanical type of tool which requires human manipulations and proper handling as it quiet difficult to use without proper knowledge. There is one more crimping tool which is the electric crimping tool. But How to Install a Sub woofer in a Factory Stereo ?

Before we look at the steps for doing the job we should understand why speakers would not be sufficient to power the music. It is because speakers can improve the effect of sound of having only higher tones. The intricacies of lower notes , tones and bass can be taken care only with sub woofer.

There are many types of electrical crimping tool which comes in many ranges. It comes in rings, blades, butts, spades etc. An electrical crimping tool may get into usage in any kind of operations like hi fi, auto wiring, appliance repair and many other mechanical process. Wires are cut to the appropriate sizes required.

Before getting into the job first the amplifier kit should be run. It is made to run by connecting it to the battery’ s positive terminal. This step is done easily. They can be made to run through the carpet , by the side of seats and then to the car trunk. This is the power wire. Another wire called remote wire also should be connected to the car trunk. Run it in the same manner as the [power wire and reach the car trunk. The fuse of car lighter or even the car stereo can be used for this connection because as we turn on the car key the amplifier gets switched on.

The connector should always be in contact with the metal portion of the wire so it is sent in to make proper connections. Only the wire for insulation can be allowed to expose out.

The subwoofer is then placed in the vehicle’s trunk. The sub is then grounded by connecting the corresponding wire to some bolt of the car. This can be done by lifting a part of the carpet for a bolt. The cable for signal, power supply and the lead for turn-on are connected.

The stereo is then replaced back in the dashboard of the car. Then the battery is reconnected by placing back the negative terminal cable on the negative terminal. The clamp can be tightened with the help of a screwdriver or a wrench.

The above were some guidelines on how to install a subwoofer in a factory stereo. The quality of the audio can be improvised by adding a powered or non-powered sub. The above was a discussion of connecting a powered sub. A non powered one can be connected only if the stereo has an amplifier built in the stereo.

Learn more about Auto. Stop by Author Name’s site where you can find out all about Car stereo and what it can do for you.