Automotive News

Music systems have become an essential one for us as it helps us to relax from our pressures. Loudness and the clarity of the music talk a lot about the quality of the system we use. To increase the loudness and clarity of the music we use amplifiers. After reading this article you will know how to connect an original car stereo to an amp.

The works requires the following tools to proceed. It will require screw drivers of the Philips company, a drill, a panel tool, a kit which contains amplifier wirings , groomets and spacers made of rubber. It will also require the use of wires and harness adapter.

First of all the negative cable has to be disconnected from the battery. This cable gives the connection between the negative lead and the vehicle. The clamp of the cable is removed using a screw driver .It is left undisturbed until the process is completed.

Now the ring terminal of the amplifier, whose fuse has been removed, is connected to the positive lead of the battery. This ring amplifier is obtained from the kit. A screw driver may be used for this purpose. A hole is drilled in the firewall which is in the compartment of the car engine. This is used for the power supply of the amplifier. The wiring is protected using groomets. The amplifier is placed in the vehicle’s trunk. In case of trucks it is placed under the seat. Spacers are used in this case to provide ventilation.

The amplifier is mounted on the trunk of the car. In the case of trucks the amplifier is mounted below the seat to provide ventilation. The vehicle’s stereo is removed. The removal procedure varies from one vehicle to other. The manual which is issued along with the vehicle by the manufacturer is to be referred often. The stereo unit is pulled to the dash till the wiring in the rear.

In the next step a hole is drilled in the compartment of the engine so as to pass the battery power to the location where the amplifier is connected. A coating of rubber grommet is made on the wire to protect the opening. It always better to place the amplifier in the trunk. In case of a truck, the amplifier can be mounted in the space below the seat but one should ensure that there is enough air circulation in that place.

The stereo system of the car is removed. The process of removing it varies from one car to another and so it is better to go through the user’s manual before doing this job. Take out the stereo so that the wires in the back side of the stereo can be accessed easily. Now the wires attached to the stereo system are removed. Then the wires are connected to a adapter. This connection is easy to make because all the wires are colour coded.

Technology has made things easy and simple though it is complicated in its own working. The above article would have taught you how to connect an original car stereo to an amp. These works must be done with caution and accuracy. Thus take time to do this simple work with care.

Want to find out more about Car Hifi, then visit Author Name’s site on how to choose the best Car Audio for your needs.