Steps To Repair A Broken Car Audio
When anyone travels for long distance, the music system of the car can be very entertaining. It is important for the lone driver to learn how to repair a car audio system since without music the drive could be very boring. There might not be any service stations in reach and with the help of few basic tools that are always kept in the car, it can be achieved. Some problems can be very minor and needs little effort. This also helps the owner to save money by not going to the service station for some minor faults.
Some tools must always be kept in the car in case of emergencies. This procedure will also use only such tools like the screwdriver, and a puller for the pulling out the fuses. The major problems faced by the audio system are due to the blown out fuse. It is hence advisable that few fuses may be kept as safety in the car always.
There is a dash board which surrounds the stereo in the car. It covers all the components and wiring that come into the stereo. To repair the stereo one must remove the dash board first. The dash board is fixed to the car stereo rigidly by use of screws. So in order to remove the dash board first we have to unscrew the connecting screws with the help of a screw driver of a suitable size. The dash board is removed from the stereo and placed aside until the operation gets over.
After removing the screws and pulling out the dash board then the stereo is also pulled out. Next the wiring is removed from the stereo so as to look at the problem inside it without causing any damage to any parts of the wire or the machine parts. In all the stereos there will be a black cable connecting the antenna to the stereo. This is used for radio reception. This wire is also unplugged from the stereo like the other wires.
Next step one must use a fuse puller for removing the fuse wire from the stereo. This is important because it is very delicate and sensitive and might get damaged while performing the operation. These fuse are present in the back side of the stereo.
The damage in the fuse wire can be found in three ways one if the wire running into the fuse wire is broken or if the color of the fuse wire changes to black that is it is burnt and the last way to find the damage is very simple that is the fuse will be melted or blown. If any of the three is noticed then it is mandatory to change the fuse wire.
If you are unable to identify the fuse box, take the car’s manual and follow the instructions present in the fuse box page. You will find a detailed flow diagram or block diagram of the audio system in that page. Identify the fuse box in the stereo with the help of that chart or diagram. Then pull it out using the fuse pullers and replace the broken fuse wire with a new one. The antenna cable and the wire harness are fixed back and the screws are replaced. The dash board is reattached firmly using the screws which were removed initially.
Thus we have learnt how to repair car audio system easily, quickly and on our own
Purchase to the best prices on Auto Hifi, then visit www.powernetshop.at to find the best advice on Car audio for you. Grab a totally unique version of this article from the Uber Article Directory
I have 3500 slt dodge diesel ext cab 2001. I was washing top of the cab of the truck and left drivers side window open. End up, getting water on the seat and door. I wipe it up and turn the ignition on the truck. I heard a pop and the radio went dead. I check the fuses and found one fuse gone. I check the radio fuse and it was good. I even pull out the good fuse and put in another fuse for the radio. Still nothing with the radio. The infinity am&fm, cd and castte player don’t work. I wondering if the there is a fuse that goes right to the radio itself. I would like to know if there is another fuse, besides the one that is in the fuse box below the steering wheel. Thanks for your time MIke